feat(v4.0.0): POST for FORTH-79, from v3's cases; not passing yet

capsules/v4/post79.4th: 537 of v3's POST cases for the FORTH-79 Required
Word Set, each carrying what the hosted v3 binary did with the same line
(error or not, the stack, the length and checksum of what it printed).
Written by v4/tools/mkpost.py.  The harness is FORTH-79 plus the two
nucleus hooks.  docs/v4.0.0/NUCLEUS.md section 6.

- NODE-ERROR has a FORTH name: how a definition in FORTH raises an error
- the boot passes POST only on seeing its tally line with fail=0
- POST is not in the boot yet (V4_POST_AT_BOOT=0); make -C v4 post runs it

Result: tests=537 pass=439 fail=98.  The 98 are not yet sorted into v4
defects and differences needing a ruling; v4/README.md has a first reading.

Verified: make -C v4 test passes; hosted-check passes on three ISAs; clean
qemu with STARFORTH_V4=1 on amd64, aarch64 and riscv64 reaches ok> with the
same hashes as hosted (logs/20261005-1601xx..1604xx).  Nothing was typed at
a bare-metal prompt.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
rajames
2026-10-05 16:04:48 -04:00
co-authored by Claude Opus 5.5
parent ed6b11ad88
commit 5d6043e37e
11 changed files with 2779 additions and 14 deletions
@@ -0,0 +1,108 @@
[=3hBdsDxe: loading Boot0002 "UEFI QEMU DVD-ROM QM00005 " from PciRoot(0x0)/Pci(0x1F,0x2)/Sata(0x2,0xFFFF,0x0)
BdsDxe: starting Boot0002 "UEFI QEMU DVD-ROM QM00005 " from PciRoot(0x0)/Pci(0x1F,0x2)/Sata(0x2,0xFFFF,0x0)
[=3hStarKernel UEFI Loader
Loading kernel from ESP...
[CKPT 001] Entered efi_main - ConOut live
RAW SERIAL UP
[CKPT 002] Serial (COM1) initialized
Monolithic build - kernel linked directly
Collecting boot information...
CmdLine: parsed OK
[CKPT 004] Command line parsed
[CKPT 005] Kernel stack allocation decided
[CKPT 006] Boot info collected (ACPI table located)
GOP: linear framebuffer found
[CKPT 007] GOP: linear framebuffer found
[CKPT 008] About to enter ExitBootServices retry loop
EBS...
EBS OK
Calling kernel_main (monolithic)...
_____ _ _ __ _
/ ____| | | |/ / | |
| (___ | |_ __ _ _ __| ' / ___ _ __ _ __ ___| |
\___ \| __/ _` | '__| < / _ \ '__| '_ \ / _ \ |
____) | || (_| | | | . \ __/ | | | | | __/ |
|_____/ \__\__,_|_| |_|\_\___|_| |_| |_|\___|_|
LithosAnanke v2.1.0
Architecture: amd64
Build: Oct 5 2026 16:01:18
UEFI BootServices: EXITED
=== StarKernel Boot Information ===
Memory map entries: 131
Total memory: 1023 MB
Usable memory: 968 MB
===================================
PMM initialized.
PMM statistics:
Total pages: 249248
Free pages : 247725
Used pages : 1523
Total MB : 973
Free MB : 967
Used MB : 5
VMM initialized (mapped RAM, CR3 switched)
VMM initialized (mapped RAM, CR3 switched)
VMM self-test: mapped OK at 0xffff800000000000
VMM self-test complete.
IDT installed.
APIC: init...
APIC: IA32_APIC_BASE MSR=0x00000000fee00900
APIC: stale-ISR drain: 0 EOI(s) issued
APIC: initialized (xAPIC MMIO, TPR=0, SIVR=0x1FF, EOI-clear)
APIC: init done
I/O APIC: init...
I/O APIC: base=0xfec00000, gsi_base=0, overrides=5
override: source=00 gsi=2 flags=0x0000
override: source=05 gsi=5 flags=0x000d
override: source=09 gsi=9 flags=0x000d
override: source=0a gsi=10 flags=0x000d
override: source=0b gsi=11 flags=0x000d
i8042: keyboard ACKed enable-scanning
i8042: IRQ1 enabled in controller config byte
I/O APIC: keyboard IRQ1 routed (masked)
Timer: init...
Timer: init start
Timer: PM_TMR_BLK discovered from FADT at port 1544
Timer: VM mode detected (hypervisor present).
Timer: HPET calibration disabled (VM-exit MMIO would poison timing).
Timer: WARNING: invariant TSC not present under hypervisor.
Timer: continuing in RELATIVE mode (no determinism guarantees).
Timer: RDTSCP not present; using RDTSC (less serialized).
Timer: CPUID frequency unavailable; trying PM Timer...
Timer: trust=1 (0=NONE,1=REL,2=ABS), TSC=2102894063 Hz
Timer: init done
Kernel heap initialized.
Heap statistics:
Total bytes: 536870872
Free bytes: 536870872
Used bytes: 0
Peak bytes: 0
Heap base addr: 24641536
Heap end addr: 561512448
Heartbeat: init...
APIC Timer: calibrating...
APIC Timer: apic_hz=1010732930, tick_hz=100, initial_count=10107329
APIC Timer: configured (masked, ready to start)
Heartbeat: init done
Kernel initialization complete.
Boot successful!
StarForth v4: one host node, the F18-derived engine
PARITY:V4_NUCLEUS words=295 image_hash=0x3ed5d5fc83f0b026
V4: capsule v4:forth79.4th signature: missing (unsigned)
PARITY:V4_CAPSULE name=v4:forth79.4th capsule_id=0xa4b74bdc7deaf204 capsule_hash=0xa4b74bdc7deaf204 dict_hash=0x118de9d37e682ea4
PARITY:OK
ok>