feat(v4.0.0): the block words are the kernel's -- v3's way in full

Ruled 2026-10-07.  BLOCK, BUFFER, UPDATE, SAVE-BUFFERS and EMPTY-BUFFERS
are each one kernel request on port 0, by block number only.  The node
has a window of four slots in its memory, as a v3 VM has; the kernel
copies blocks into it, keeps the record of which block is in which slot,
and decides when a block is written (v4/system/blocks.c).  The node keeps
no record and gives the kernel no address, so a request cannot overwrite
the node's code.  When a block is written stays FORTH-79's: UPDATE marks
it.  When the chain of devices changes the slots are let go, as in v3.

The window is 512 cells more than the two buffers were; the dictionary
space ends that much lower, at 13824.

MESH.md 8.5 had said, from the review, that a v3 VM's BLOCK is the
kernel's buffer.  It is not, and the section now says what was reported,
what v3 does, and what was ruled.

make -C v4 test, sanitize and hosted-check pass; amd64, aarch64 and
riscv64 boot, POST 538 of 538, the same hashes on all six:
logs/20261007-092835, -093112, -093456.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
rajames
2026-10-07 09:37:30 -04:00
co-authored by Claude Opus 5.5
parent 7f4d946d2e
commit 9bfd5071d2
21 changed files with 991 additions and 330 deletions
@@ -0,0 +1,148 @@
[=3hBdsDxe: loading Boot0002 "UEFI QEMU DVD-ROM QM00005 " from PciRoot(0x0)/Pci(0x1F,0x2)/Sata(0x2,0xFFFF,0x0)
BdsDxe: starting Boot0002 "UEFI QEMU DVD-ROM QM00005 " from PciRoot(0x0)/Pci(0x1F,0x2)/Sata(0x2,0xFFFF,0x0)
[=3hStarKernel UEFI Loader
Loading kernel from ESP...
[CKPT 001] Entered efi_main - ConOut live
RAW SERIAL UP
[CKPT 002] Serial (COM1) initialized
Monolithic build - kernel linked directly
Collecting boot information...
CmdLine: parsed OK
[CKPT 004] Command line parsed
[CKPT 005] Kernel stack allocation decided
[CKPT 006] Boot info collected (ACPI table located)
GOP: linear framebuffer found
[CKPT 007] GOP: linear framebuffer found
[CKPT 008] About to enter ExitBootServices retry loop
EBS...
EBS OK
Calling kernel_main (monolithic)...
_____ _ _ __ _
/ ____| | | |/ / | |
| (___ | |_ __ _ _ __| ' / ___ _ __ _ __ ___| |
\___ \| __/ _` | '__| < / _ \ '__| '_ \ / _ \ |
____) | || (_| | | | . \ __/ | | | | | __/ |
|_____/ \__\__,_|_| |_|\_\___|_| |_| |_|\___|_|
LithosAnanke v2.1.0
Architecture: amd64
Build: Oct 7 2026 09:28:08
UEFI BootServices: EXITED
=== StarKernel Boot Information ===
Memory map entries: 131
Total memory: 1023 MB
Usable memory: 966 MB
===================================
PMM initialized.
PMM statistics:
Total pages: 248746
Free pages : 247223
Used pages : 1523
Total MB : 971
Free MB : 965
Used MB : 5
VMM initialized (mapped RAM, CR3 switched)
VMM initialized (mapped RAM, CR3 switched)
VMM self-test: mapped OK at 0xffff800000000000
VMM self-test complete.
IDT installed.
APIC: init...
APIC: IA32_APIC_BASE MSR=0x00000000fee00900
APIC: stale-ISR drain: 0 EOI(s) issued
APIC: initialized (xAPIC MMIO, TPR=0, SIVR=0x1FF, EOI-clear)
APIC: init done
I/O APIC: init...
I/O APIC: base=0xfec00000, gsi_base=0, overrides=5
override: source=00 gsi=2 flags=0x0000
override: source=05 gsi=5 flags=0x000d
override: source=09 gsi=9 flags=0x000d
override: source=0a gsi=10 flags=0x000d
override: source=0b gsi=11 flags=0x000d
i8042: keyboard ACKed enable-scanning
i8042: IRQ1 enabled in controller config byte
I/O APIC: keyboard IRQ1 routed (masked)
Timer: init...
Timer: init start
Timer: PM_TMR_BLK discovered from FADT at port 1544
Timer: VM mode detected (hypervisor present).
Timer: HPET calibration disabled (VM-exit MMIO would poison timing).
Timer: WARNING: invariant TSC not present under hypervisor.
Timer: continuing in RELATIVE mode (no determinism guarantees).
Timer: RDTSCP not present; using RDTSC (less serialized).
Timer: CPUID frequency unavailable; trying PM Timer...
Timer: trust=1 (0=NONE,1=REL,2=ABS), TSC=2097105936 Hz
Timer: init done
Kernel heap initialized.
Heap statistics:
Total bytes: 536870872
Free bytes: 536870872
Used bytes: 0
Peak bytes: 0
Heap base addr: 24641536
Heap end addr: 561512448
Heartbeat: init...
APIC Timer: calibrating...
APIC Timer: apic_hz=1008484717, tick_hz=100, initial_count=10084847
APIC Timer: configured (masked, ready to start)
Heartbeat: init done
Kernel initialization complete.
Boot successful!
StarForth v4: one host node, the F18-derived engine
V4: capsule v4:nucleus-64.f18 signature: missing (unsigned)
PARITY:V4_NUCLEUS name=v4:nucleus-64.f18 capsule_id=0x1d4ff6398f190c13 capsule_hash=0x1d4ff6398f190c13 words=310
V4: capsule v4:forth79.4th signature: missing (unsigned)
PARITY:V4_CAPSULE name=v4:forth79.4th capsule_id=0x4055641ee17d176b capsule_hash=0x4055641ee17d176b dict_hash=0x1c771623a746cc7f
V4: capsule v4:post79.4th signature: missing (unsigned)
PARITY:V4_POST tests=538 pass=538 fail=0
PARITY:V4_CAPSULE name=v4:post79.4th capsule_id=0xb26d1b974884179d capsule_hash=0xb26d1b974884179d dict_hash=0xd8221bd6371d0ef3
PARITY:OK
POST: PASSED
[HADES][INFO ] [KRELTSC: 0] blk: raw device LBN 2048..3071 (1024 blocks)
PCI: init...
PCI: ECAM mapped (amd64)
virtio-blk: found device
Artemis: virtio-blk attached
[HADES][INFO ] [KRELTSC: 83774187] blk: disk 'StarForth Volume' v2 LBN 3072..789009 (785938 user b
ok> : SQ DUP * ;
ok
ok> 7 SQ . 3 4 U* . .
49 0 12 ok
ok> COLD
FORTH-79 Cold Start
System initialized.
ok
ok> 3 4 U* . .
0 12 ok
ok> FORGET U*
Protected word
ERROR
ok> 9 KERNEL-WORD ASK9 ASK9
Argument out of range
ERROR
ok> 1 BLOCK C@ . 2047 BLOCK C@ .
0 0 ok
ok> 2100 BLOCK 1024 BLANK 65 2100 BLOCK C! UPDATE SAVE-BUFFERS EMPTY-BUFFERS 2100 BLOCK C@ .
65 ok
ok> 3072 BLOCK C@ .
0 ok
ok> 3072 BLOCK DROP UPDATE SAVE-BUFFERS
Storage refused
ERROR
ok> 9999999 BLOCK
Block out of range
ERROR
ok> BYE
BYE: cold restart